Welltech SPCI2S Intel NetStructure SS7 Boards Manuale Utente Scaricare il pdf (Pagina 38)

SS7 Programmer’s Manual for SPCI2, SPCI4 and CPM8 Issue 2 Page 38

Parameter Description:

board_type

The type of board to be reset. This should be set to 2 for SPCI2S, SPCI4 and

CPM8 boards.

phy_id

The physical id for the board. This field should be set to the same value as the

board_id. (ie 0 .. one less than the number of boards supported).

code_file

Null terminated string giving the filename of the code file to be downloaded to

the board.

run_mode

Number taken from the following table to indicate which protocols are to be run:

NOTE: It is only possible to activate protocols that have been licensed to run on

the board by use of a suitable licence button.

run_mode Mnemonic Protocols selected to run on the board

1 DTI Digital Trunk Interface only, no protocol software. This mode does

NOT require the use of a software licence button).

2 MTP2 MTP2 protocol only.

3 MTP MTP3 plus MTP2 protocols.

4 ISUP ISUP, standard version, up to 256 circuits plus all MTP.

5 ISUP-L ISUP, large version, up to 4096 circuits plus all MTP.

6 TUP TUP, standard version, up to 256 circuits plus all MTP.

7 TUP-L TUP, large version, up to 4096 circuits plus all MTP.

10 SCCP-CL SCCP connectionless operation plus all MTP.

11 SCCP-CO SCCP connection-oriented plus connectionless plus all MTP.

12 TCAP TCAP plus SCCP-CL plus all MTP.

13 ISTC ISUP standard version plus TCAP, plus SCCP-CL plus all MTP

14 MAP MAP plus TCAP plus SCCP-CL plus all MTP.

15 IS41 IS41 plus TCAP plus SCCP-CL plus all MTP.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 106 107

Nessun commento

Welltech SPCI2S Intel NetStructure SS7 Boards Manuale Utente Pagina 38